Best Computer Heatsinks
Enter your model number to make sure this fits.
Reviews
Find Best Price at Amazon"Kind of expensive for what you're getting but not too bad."
"Worked as intended no complaints decent prize for amount."
"Used to replace paste in PS4, works perfectly."
"A tiny dot for me was all that's needed when placed on the center of the processor."
"I could post links to review sites, specifying what delta T it has on a system, but you can find that yourself."
"Highly renown as the best thermal paste out there and without a doubt, having used other disappointing thermal paste's, this one definitely stands out as the best I've used."
Mugen 5 is the latest model of the Mugen series with upgraded mounting system(H.P.M.S.). Enter your model number to make sure this fits.
Reviews
Find Best Price at Amazon"My 8600k is delidded and stuffed with liquid metal on both sides of the heat spreader, at 5.2ghz under load, the Scythe Mugen 5 kept the 6 cored beast at a stable 48 Celsius."
"I have it pinned at 100% fan speed for max cooling and it's still quieter than my previous AIO water cooler."
"With the stock Ryzen 1700 Wraith cooler and Arctic MX-4 thermal paste at 3.6Ghz at 1.35V, my idle temp was between 35*-40*C. CPU-Z with all cores the temp shot up to 84.5*C, but was stable. Idle at 3.6Ghz at 1.35V, the temps were between 30*-35*C. CPU-Z was a cool 59.13*C. At 3.9Ghz, 1.4V idle temps were around 45* and the CPU-Z never went above 66.7* after 20 minutes."
"Will not fit on to my 1150 motherboard, screws are not long enough."
SPECIFICATION：. - Size: 25mm * 56mm * 15mm. - Voltage: 5V. - Current: 0.3A. - Power: 1.5W. - Speed: 7500rpm. - Noise: 37DBA. - Net weight: 40g. Custom size fan can fit most of the raspberry Pi case.
Reviews
Find Best Price at Amazon"It did come with the thinner tape and was very easy to install, the blue plastic covering was a bit hard to peel off with short nails, but once I got it off it was very easy to just place on the fan."
"Used in Nespi Case, unfortunately poor ventilation in the case caused high temperatures, maybe the next model Nespi will have better ventilation."
"This case works really well, and is incredibly easy to set up.The fit and finish makes it my favorite case to date."
"I took it a step further and used thermal adhesive paste and got around 42C at full load."
"These fans are quiet and provide great cooling and AND they fit in the NesPi case by Retroflag which in my opinion is the only way to go for a pi case."
"I installed the product in my PI raspberry and it worked without problems."
"Easy to install into a NesPi, works great."
"The best fans I have ever used."
Best Thermal Management Products
The NH-D15 features two of Noctua's premium class NF-A15 140mm fans. 6 heatpipe dual radiator design.
Reviews
Find Best Price at Amazon"I installed this cooler on my ASUS Sabertooth X99 along with ADATA DDR4-2800 32GB RAM. Using silent PWM profile from the Motherboard I had I can keep my 4.2GHz 5820K cool with merely a 240RPM. The cooler may have some fitment issues with tall RAM heatspreader."
"HUGE, it's HUGE. Does it's job as described."
"What a difference over the stock AMD cooling fan (that sounded like a small jet engine in my living room). No big deal, just do not unscrew the 4 mounting screws at the same time, the back plate will fall off."
"I have: - ASUS X99-A/USB 3.1 LGA 2011-v3 Intel X99 SATA 6Gb/s USB 3.1 USB 3.0 ATX Intel Motherboard. - Intel Core i7-5820K Haswell-E 6-Core 3.3GHz LGA 2011-v3 140W Desktop Processor BX80648I75820K. I went through 2 heat sinks on my Intel i7."
"Knocked 20C degrees off my CPU temp vs. the Intel RTS2011LC liquid cooler for my overclocked i7-3960X, even without the optional second fan."
"My system makes minimal noise but I can't tell if any is from the cpu fan as the case has 2 fans and two disk drives always running."
"I was about to get a different brand of liquid cooler when I read the Maximum PC "Best of the Best" article and they recommended the Noctua as the best air cooler. I've lost count of the number of boxes I've built over the years and the corresponding number of coolers I've installed. I was able install it in no time and immediately noticed that my PC was not only quieter but also ran cooler by about 6 degree Celsius."
Best Thermal Cutoffs
This is an Aftermarket replacement part. Enter your model number to make sure this fits.
Reviews
Find Best Price at Amazon"Btw in a pinch, the one time use fuse on the right can be reset by throwing it on the floor, flat side down, increasingly hard until you get continuity through it."
"One of the many parts I purchased trying to repair my dryer when it quit heating."
"Unfortunately, I cannot comment on quality or duration of this product as it did not fix my issue (timer problem) and the dryer has not been used since part replacement."
"Pay attention to your wires labeling and all should go well and the fuse kit works it's just the after market sears alternate optional recommendation."
"My father said that it is just as good as the expensive stuff from the brand name companies like Sears and Home Depot, but it won't leave such an impact on your wallet."
"Ordered this thinking that how much cheaper (quality) could a simple aftermarket part like this be?"
"These parts are not Whirlpool manufactured parts."
"Lo and behold, I found many, MANY sources for needed part number, most of them bloody cheap, AND with the thermostat, all for about a third of what the ONE cutoff was with Parts Direct. Well, there is a reason as to why the cost difference, as you can tell by the life that the original cutoff gave us (nearly 20 years) versus the time we had to enjoy the replacement (6 days)."
Best Electronic Cooling Fans
The NH-D15 features two of Noctua's premium class NF-A15 140mm fans. 6 heatpipe dual radiator design.
Reviews
Find Best Price at Amazon"I installed this cooler on my ASUS Sabertooth X99 along with ADATA DDR4-2800 32GB RAM. Using silent PWM profile from the Motherboard I had I can keep my 4.2GHz 5820K cool with merely a 240RPM. The cooler may have some fitment issues with tall RAM heatspreader."
"HUGE, it's HUGE. Does it's job as described."
"After installing this beautiful cooler it dropped my temps down 30c at full load and won't let my cpu get above 58c."
"What a difference over the stock AMD cooling fan (that sounded like a small jet engine in my living room). No big deal, just do not unscrew the 4 mounting screws at the same time, the back plate will fall off."
"I have: - ASUS X99-A/USB 3.1 LGA 2011-v3 Intel X99 SATA 6Gb/s USB 3.1 USB 3.0 ATX Intel Motherboard. - Intel Core i7-5820K Haswell-E 6-Core 3.3GHz LGA 2011-v3 140W Desktop Processor BX80648I75820K. I went through 2 heat sinks on my Intel i7."
"Knocked 20C degrees off my CPU temp vs. the Intel RTS2011LC liquid cooler for my overclocked i7-3960X, even without the optional second fan."
"My system makes minimal noise but I can't tell if any is from the cpu fan as the case has 2 fans and two disk drives always running."