Best Pneumatic Hold Down Clamps
This is a dog clamp and is used with dog tables. With a 7.5" tall 3/4" diameter dog peg for a vertical clamping range up to 5.5" above the table.
Reviews
Find Best Price at Amazon"Had to shorten the stake because I have drawers below my bench."
"Works well."
"Works as advertised, which is to say it works well."
"Works as advertised and simple to use."
"Very happy."
"I doubled up the base on my workbench by adding a piece of 3/4" plywood below table - now works fine."
"Good product, but it's much cheaper at sears."
"I find this clamp a bother to adjust and I question the damage that the knurled shaft will do to an MFT table after much clamping."
Improve your shop-made jigs and fixtures with this quick action cam clamp. Enter your model number to make sure this fits.
Reviews
Find Best Price at Amazon"Good product, did the job well."
"This clamp was a little light."
Table T-Slot size: 1/2". Stud size: 3/8"-16. T Nut No. Includes: 24 studs (4 pieces of each 3",4",5",6",7",8" long), 6 step block pairs.
Reviews
Find Best Price at Amazon"Arrived faster than expected, and hey, mine are perfectly sized!"
"two pieces of set are so bad they can't be used."
"T-Nuts were not the correct dimension and had to be machined."
"Would do it again if need to great product with quick delivery."
Best Pneumatic Hold Down Clamps
Table T-Slot size: 1/2". Stud size: 3/8"-16. T Nut No. Includes: 24 studs (4 pieces of each 3",4",5",6",7",8" long), 6 step block pairs.
Reviews
Find Best Price at Amazon"Arrived faster than expected, and hey, mine are perfectly sized!"
"two pieces of set are so bad they can't be used."
"T-Nuts were not the correct dimension and had to be machined."
"Would do it again if need to great product with quick delivery."
