Best Recessed Lighting Trims
Part Number: B630W-WH. ✔ Fits in all 6" standard recessed housing cans including Halo's and Juno's.
Reviews
Find Best Price at Amazon"These are an excellent deal and higher quality compared to similar products at home depot that cost over $7 each."
"The little ring around the can is plastic, but that isn't really a huge deal - they probably all are."
"I replaced all my kitchen recessed light cans with these since mine had yellowed with time."
"Bought these after pricing similar ones at the local box store that cost over $7 each."
"My is perfect, don't really like the spring they're little longer and softer than I like."
"The foam seal is junk, does not fit, and went straight in trash when I installed."
"We updated our kitchen lighting, including new baffles on Halo fixtures and new LED bulbs."
"Nice refresh for my old recessed lights and matching them to my new can lights in my newly renovated kitchen."
Designed for 4 inch standard recessed cans and ceiling lighting fixtures，fit Halo/Juno remodel recessed housing.
Reviews
Find Best Price at Amazon"I recently remodeled my kitchen with stainless steel appliances and brushed nickle fittings."
"Since all my appliances in the kitchen are stainless steel, I thought I would add these trims to match."
"Love the cans, not completely sold on the retaining mechanism and the play between the reflector and the rim."
"Will not work with certain led br-20 flood bulbs unless you use a socket extender that they sell also."
"Look beautiful and easy installation, now when you receive the item it has a small opening or a reflector and that will not accept all the bulbs but that opening or the reflector could be open with a plier and than it could be open and bigger bulbs could be fit in the opening and the trim is 4 in only."
"I got the six pack along with two individual ones for my kitchen's 8 recessed lights."
"Product was attractive and good quality but did not work with my 50w MR16 recessed halogen cans as there was no way to anchor the bulbs (which were too small for the opening)."
"these are as good or better quality than what you'll find at big box stores at ~40% less money."
Designed for 4 inch standard recessed cans and ceiling lighting fixtures，fit Halo/Juno remodel recessed housing.
Reviews
Find Best Price at Amazon"I recently remodeled my kitchen with stainless steel appliances and brushed nickle fittings."
"Since all my appliances in the kitchen are stainless steel, I thought I would add these trims to match."
"Love the cans, not completely sold on the retaining mechanism and the play between the reflector and the rim."
"Will not work with certain led br-20 flood bulbs unless you use a socket extender that they sell also."
"Look beautiful and easy installation, now when you receive the item it has a small opening or a reflector and that will not accept all the bulbs but that opening or the reflector could be open with a plier and than it could be open and bigger bulbs could be fit in the opening and the trim is 4 in only."
"I got the six pack along with two individual ones for my kitchen's 8 recessed lights."
"Product was attractive and good quality but did not work with my 50w MR16 recessed halogen cans as there was no way to anchor the bulbs (which were too small for the opening)."
"these are as good or better quality than what you'll find at big box stores at ~40% less money."
Best Recessed Lighting Housings
PIONEER. INNOVATIVE. VISIONARY. Sunco Lighting is a proud American seller and a world leader in manufacturing superior LED lighting products. ✔ COST SAVINGS: Because IC rated fixtures minimize moisture condensation, they reduce the need for electrician call outs and other repairs.
Reviews
Find Best Price at Amazon"Remove all clips and foam from housing, open electric box and remove long foam strip. After can fits into hole, remove and run required wiring (note, only 2 additional wires can enter can junction box, so plan to daisy chain in series rather than use a single light to distribute to multiple cans. Place foam strip around can on outside (will fit between drywall and can for seal) do not pull tightly on foam as it will stretch and become too thin. Remove foam tabs from metal clips. Place metal clips back into can as they were shipped, long tab on top. Push up on the bottom section of the tab with finger or end of flat head until the small metal tab is up in half circle of can housing. Place foam tabs vertically onto metal clips previously installed to seal the openings."
"I have attached a few photos but all you really need to do is shut off the power off, uninstall the existing unit, cut the hole with the diameter the same as the sticker they provide and then you plug the wire into the unit and install your trim and light combo. If you are going to run a series of these like in a kitchen, take the one hot (existing light switch) wire and go to Lowe's or Home Depot and get extra 14 gauge wire in the electrical section and then splice each light from that hot wire."
"The clips are not held in by sticker like another post mentions."
"It is advertised as an "IC" (insulation contact) rated can, BUT, I have to believe that ONLY applies if you are using the new LED recessed light "modules" (that are show on the page). On some cans, the clips popped into place easily; on others I had to fight with the clips to click up into place."
Best Recessed Lighting Housing & Trim Kits
Globe Electric's 10 pack 4" Swivel Spotlight Recessed Lighting Kit with round trim and white finish is the perfect way to brighten up the interior of your home or commerce with style. ✔ ROBUST CONSTRUCTION: galvanized steel, longer shaft, large accessible electrical box with removable side panels and tempered steel clips.
Reviews
Find Best Price at Amazon"So I went ahead and contacted Globe Electric customer support and they confirmed that this model is indeed IC-rated if used with LED bulbs. The lights themselves are great, easy to install, can swivel in any direction, and the nickel finish gives a stylish appearance.They're exceedingly bright when used in conjunction with a 50w LED bulb equivalent. Feeding a bent coat hanger through a small hole in the drywall is a great method of determining if there's any obstructions."
"I put an Eco Smart ECS 20 50WE WW FL 120 TP bulb in each fixture and they look incredible at night."
"well made, good functionality."
"I got three of these and they work great for dimming lights."
"All other light switches in the house simply controlled an outlet somewhere in the room, which meant that we were relying on lamps all over the place. Just don't cut the hole too close to a ceiling joist, and make sure there are no other obstructions immediately above."
"Had some recessed lights installed around my house."
"Before installation i put some on test for 48 hours using the LED bulbs and they didn't even get a little warm."
"You just have to decide if you want them to swivel left to right or front to back before you install them."